Audiokinetic's Community Q&A is the forum where users can ask and answer questions within the Wwise and Strata communities. If you would like to get an answer from Audiokinetic's Technical support team, make sure you use the Support Tickets page.

My device does not show up in Remote Connections

0 votes
Hi all.

I've been trying to start the Wwise-101 course today. I was getting through the first lesson and had no problems finding my device and connecting. Then I needed to connect a different project and it would just stall while I was trying to connect. I ended up removing my device from the history section thinking I could reload it and now it is just gone. I have tried redownloading Wwise several times and tried to connect to my IPv4 address but nothing is working.

Any suggestions on what I need to do? I really want to get through this course and get WWise under my belt.

Cheers,
Will
in General Discussion by William B. (100 points)
I ran into the same issue and the workaround I found is
1. Run Cube
2. Open Terminal
3. enter lsof -i | grep CubeMac
4. It will show something like
     CubeMacPr xxx xxx ...... TCP *:53428 (LISTEN)
     The number 53428 may vary from time to time.
5. Go to wwise --> Connect to Remote Platform --> Connect To IP, and put
      127.0.0.1:53428
by Song W. (100 points)

Please sign-in or register to answer this question.

Powered by Question2Answer
...