At times, a transition sounds better if another piece of music plays over the end of the source and the beginning of the destination. This bridging piece of music is called a transition segment, and you can use one for any transition in Wwise. The following illustration shows how a transition segment is played between the source and destination of a music transition.
 |
You can also use any combination of the pre-entry and post exit areas of the source, destination, and transition segments to create even more seamless transitions.
Any Music Segment can be used as a transition segment. To learn how to create a segment, refer to Working with Music Tracks and Music Segments.
![[Note]](/images/2023.1.8_8601/?source=Help&id=note.png) | Note |
|---|---|
If a Work Unit containing the transition segment has been unloaded from the project, the transition segment will be highlighted in yellow. |
To use a transition segment:
Load a Music Switch or Playlist Container into the Property Editor.
Switch to the Transitions tab.
Select a transition in the transition matrix.
Select Use transition segment.
Do one of the following:
Drag a segment from the Project Explorer to the Transition Segment field.
Click the Browse button (...) and select a segment from the Project Explorer - Browser.
If you want the pre-entry of the transition segment to play, select Play transition pre-entry.
If you want the transition to begin playing with a fade-in, select Fade-in.
If you want the post-exit of the transition segment to play, select Play transition post-exit.
If you want the transition to stop playing with a fade-out, select Fade-out.
Note For more information about editing the fade-in and fade-out properties of a transition segment, refer to Editing fades.
Was this page helpful?
Need Support?
Questions? Problems? Need more info? Contact us, and we can help!
Visit our Support pageTell us about your project. We're here to help.
Register your project and we'll help you get started with no strings attached!
Get started with Wwise