Version

menu_open

Opus Parameters

The standard Opus Encoder is supported on all platforms, contrary to the OpusNX version. The parameters are similar, as the inner algorithm is the same. These are described below:

Interface Element

Description

Bitrate/quality

This slider specifies the bitrate in kilo bits per second (kbit/s) for a single Opus channel. The higher the bitrate, the better the sound quality.

Frame Size

The frame length for Opus packets, in ms. Smaller gives lower latency, but worse compression and worse quality. Range is 2.5 to 60 ms. It is not recommended to use 2.5 ms except for very specific cases as it affects the quality a lot.

For more general information about the Opus codec please refer to: https://wiki.xiph.org/OpusFAQ.


Was this page helpful?

Need Support?

Questions? Problems? Need more info? Contact us, and we can help!

Visit our Support page

Tell us about your project. We're here to help.

Register your project and we'll help you get started with no strings attached!

Get started with Wwise