Version
menu_open

Changing the Timeline Mode

The timeline in the Position Editor (3D Automation) can be in one of two modes:

  • Linear: Control points are automatically placed at even intervals along the timeline.

  • Non-linear: Control points are placed anywhere on the timeline.

Linear mode produces a constant motion from one key to the next as an object travels along the path. Non-linear mode, on the other hand, can be used to speed up and slow down an object as it travels between points along the path. Linear is the default timeline mode.

You can further configure certain behaviors of the timeline by clicking the Configure Timeline button. For more information, refer to Configuring the Positioning Timeline.

To change the timeline mode:

  1. In the Position Editor (3D Automation), do one of the following:

    • Clear the Linear option to set the timeline mode to non-linear.

    • Select the Linear option to set the timeline mode to linear.

Was this page helpful?

Need Support?

Questions? Problems? Need more info? Contact us, and we can help!

Visit our Support page

Tell us about your project. We're here to help.

Register your project and we'll help you get started with no strings attached!

Get started with Wwise