Wwise Help

	Note
	For context, please reference the first example.

The effect of emitter orientation described below applies only when Spatialization Mode is set to Position + Orientation. A discussion follows, below, about the use of Position + Orientation versus Position Spatialization Modes.

The following example is similar to the previous one, but the listener faces east. This illustrates the behavior of two different orientations at once:

The Effect of Relative Emitter Orientation with Various Spread Values
Spread	Relative emitter position and orientation	Placement of Virtual Sources and Output Bus Channel Energy
0% Spread
30% Spread
70% Spread
100% Spread

Just to make sure you understand the difference between relative emitter position and relative emitter orientation, here is the result with a relative emitter position of 45 degrees, a relative emitter orientation of 90 degrees, and 70% Spread. This can be viewed as if the listener was penetrating the emitter's sound field from the southwest, facing east. The green and red emitter channels are somewhat placed at the front left and front right from the listener, and the blue channel is starting to envelop it.

Effective Panning of an Emitter Located 45 Degrees from the Listener's Azimuth, with Relative Orientation of 90 degrees and a 70% Spread
Spread	Relative emitter position and orientation	Placement of Virtual Sources and Output Bus Channel Energy
70% Spread

From the examples above it should be clear that emitter orientation only affects multichannel sources. Orientation-driven rotation works best when the multichannel source represents a "sound field", an "ambience" with its sonic constituents panned and rendered in the multichannel material. At run-time, Wwise rotates this material based on the listener and the emitter orientation, effectively tying the ambience to the 3D world geometry.

However, it sometimes happens that multichannel files are not necessarily representations of sound fields, but instead are simply sounds that were authored so that they given an impression of spatial extent. This is often the case with stereo sounds. In these cases, the spatial extent effect is optimal with the original channel separation, and any attempt to rotate them is undesirable. For this type of content, users can opt out of the emitter orientation with the Spatialization Mode Position.

Proceed to the next 3D positioning example: Focus.