Wwise uses the low frequencies of an audio signal to generate the corresponding motion signal. To give you additional control and flexibility over which frequencies are kept and which ones are discarded, Wwise allows you to set the cut off frequency using the Motion Low Pass property.
![[Note]](/images/2017.1.9_6501/?source=Help&id=note.png) |
Note |
|---|---|
|
The Motion Low Pass property only determines which frequencies are extracted to generate the motion signal. It has no impact on the original sound. |
To specify the motion signal's cut-off frequency:
-
Load an object into the Property Editor.
-
In the Audio to Motion Settings group box, modify the Motion Low Pass value to set the cutoff frequency that will be used to generate the motion signal.
Was this page helpful?
Need Support?
Questions? Problems? Need more info? Contact us, and we can help!
Visit our Support pageTell us about your project. We're here to help.
Register your project and we'll help you get started with no strings attached!
Get started with Wwise