Wwise Help

Name

The name of the object.

Notes

Any additional information about the object properties.

Controls the Mute and Solo states for the object and shows the implicit mute and solo states for the object.

Muting an object silences this object for the current monitoring session. Soloing an object silences all the other objects in the project except this one.

A bold M or S indicates that the Mute or Solo state has been explicitly set for the object. A non-bold M or S with faded color indicates that the object's Mute or Solo state was implicitly set from another object's state.

Muting an object implicitly mutes the descendant objects.

Soloing an object implicitly mutes the sibling objects and implicitly solos the descendant and ancestor objects.

	Tip
	Hold the Ctrl key while clicking a solo button to exclusively solo the object for which the solo button is associated.

	Note
	Mute and Solo are designed to be used for monitoring purposes only and are not persisted in the project or stored in the SoundBanks.

Bus Volume

The attenuation (level or amplitude) applied on the audio signal at the bus or Auxiliary Bus level. Refer to Understanding the Voice Pipeline for more information about volumes.

Default value: 0
Range: -200 to 200
Units: dB

	Note
	The default slider range is from -96 to +12. You can go over those limits by entering the value directly, or by rolling the mouse while the focus is on the edit control.

Voice Volume

The attenuation (level or amplitude) applied on the current object before it is routed to a bus or sent to an Auxiliary Bus. Refer to Understanding the Voice Pipeline for more information about volumes.

Default value: 0
Range: -400 to 400
Units: dB

	Note
	The default slider range is from -96 to +12 dB. You can go over those limits by entering the value directly or by rolling the mouse while the focus is on the edit control.

Voice Pitch

The playback speed of an audio object, where:

	Tip
	1,200 cents is equivalent to one octave.

Default value: 0
Range: -4,800 to +4,800
Units: Cents

Voice Low-pass Filter

A recursive filter that attenuates high frequencies based on the value specified.

The units for this filter represent the percentage of low-pass filtering that has been applied, where 0 means no low-pass filtering (signal unaffected) and 100 means maximal attenuation.

Default value: 0
Range: 0 to 100
Units: Percent
(For more detail, see Wwise LPF and HPF Value Cutoff Frequencies.)

Voice High-pass Filter

A recursive filter that attenuates low frequencies based on the value specified.

The units for this filter represent the percentage of high-pass filtering that has been applied, where 0 means no high-pass filtering (signal unaffected) and 100 means maximal attenuation.

Default value: 0
Range: 0 to 100
Units: Percent

(Meter)

A per channel peak meter. For more information about speaker configurations and channels, refer to Understanding Channel Configurations.

The signal level is green under -6 dB, yellow from -6 to 0 dB, and red over 0 dB.

	Note
	Meters are only available on mixing busses. To be a mixing bus, a bus must be the master or an Auxiliary Bus, or an Audio Bus with at least one effect enabled, positioning enabled, or not using the "Parent" channel configuration. Refer to Mixing Versus Non-Mixing Busses for more information on this distinction.

Audio Device

Audio device used to output the audio generated by this bus. Select among the existing Audio Device ShareSets defined in the Audio Device section. If you want to use a third-party Audio Device plug-in, you may need to create a ShareSet first.