버전
menu_open

Setting Crossfade Modes

Wwise can handle crossfading in various ways, all depending on your preferences. You can use the following three modes to adjust the crossfading between the objects in your blend tracks:

  • None: The property of the RTPC transitions from its maximum to its minimum value or vice-versa instantly when crossing the overlapping block's boundaries.

  • Automatic (default): The fading range depends on the width of the overlap with the neighboring block. If there is no neighboring block, there is no fade.

  • Manual: You can move the point where the fade-in ends or the fade-out begins. The beginning of a fade-in or end of a fade-out will always begin at the outside lower corner of the overlapping block.

[Note] Note

You can also modify the shape of the crossfade curves. For information on setting curve shapes, refer to Specifying the Shape of the Curve Between Control Points.

To select a crossfade mode:

  1. Right-click the edge of a block and click a mode.

Related Topics

이 페이지가 도움이 되었나요?

지원이 필요하신가요?

질문이 있으신가요? 문제를 겪고 계신가요? 더 많은 정보가 필요하신가요? 저희에게 문의해주시면 도와드리겠습니다!

지원 페이지를 방문해 주세요

작업하는 프로젝트에 대해 알려주세요. 언제든지 도와드릴 준비가 되어 있습니다.

프로젝트를 등록하세요. 아무런 조건이나 의무 사항 없이 빠른 시작을 도와드리겠습니다.

Wwise를 시작해 보세요