Wwise can handle crossfading in various ways, all depending on your preferences. You can use the following three modes to adjust the crossfading between the objects in your blend tracks:
-
None: The property of the RTPC transitions from its maximum to its minimum value or vice-versa instantly when crossing the overlapping block's boundaries.
-
Automatic (default): The fading range depends on the width of the overlap with the neighboring block. If there is no neighboring block, there is no fade.
-
Manual: You can move the point where the fade-in ends or the fade-out begins. The beginning of a fade-in or end of a fade-out will always begin at the outside lower corner of the overlapping block.
![[Note]](/images/2017.1.9_6501/?source=Help&id=note.png) |
Note |
|---|---|
|
You can also modify the shape of the crossfade curves. For information on setting curve shapes, refer to Specifying the Shape of the Curve Between Control Points. |
To select a crossfade mode:
-
Right-click the edge of a block and click a mode.
Cette page a-t-elle été utile ?
Besoin d'aide ?
Des questions ? Des problèmes ? Besoin de plus d'informations ? Contactez-nous, nous pouvons vous aider !
Visitez notre page d'AideDécrivez-nous de votre projet. Nous sommes là pour vous aider.
Enregistrez votre projet et nous vous aiderons à démarrer sans aucune obligation !
Partir du bon pied avec Wwise