Applying Batch Rename changes
After Specifying Batch Rename settings, but before applying them, it
is good practice to check the Preview panel for the impact
of your specified rename settings.
To review the preview:
Check for a count of detected errors and warnings in the field just below the
panel.
Sort the objects by the message type column (click the column header without a
title, to the right of After).
Objects with error messages are listed first, with warning messages second, and
without messages third.
Look through the objects with messages by inspecting the Before and After columns.
The After column displays the effect of the
Settings panel entries.
Isolate what, if anything (warnings do not necessarily imply required changes), you
need to adjust.
Change the Settings panel entries as desired, then
click the Preview panel.
The panel updates to show the impact of your changes.
Continue adjusting the settings until there are no error messages and you are
satisfied with the forecast results (in the After
column).
To apply the rename settings to all the listed objects:
Click Rename All to change the object names or
comments listed in the Before column of the Preview panel.
![[Note]](/images/2023.1.5_8522/?source=Help&id=note.png) | Note |
---|
The Batch Rename applies to all the objects that were added in the Preview panel, even if some of those objects are filtered
from view with a search filter. |
All the listed object names or comments are changed to their After column values.
The message type and Message columns update to
respectively display a green square and a Successfully
renamed message.
Tell us about your project. We're here to help.
Register your project and we'll help you get started with no strings attached!
Get started with Wwise