Version
menu_open
Warning: you were redirected to the latest documentation corresponding to your major release ( 2022.1.17.8543 ). Should you wish to access your specific version's documentation, please download the offline documentation from the Audiokinetic Launcher and check the Offline Documentation option in Wwise Authoring.

Setting Crossfade Modes

Wwise can handle crossfading in various ways, all depending on your preferences. You can use the following three modes to adjust the crossfading between the objects in your blend tracks:

  • None: The property of the RTPC transitions from its maximum to its minimum value or vice-versa instantly when crossing the overlapping block's boundaries.

  • Automatic (default): The fading range depends on the width of the overlap with the neighboring block. If there is no neighboring block, there is no fade.

  • Manual: You can move the point where the fade-in ends or the fade-out begins. The beginning of a fade-in or end of a fade-out will always begin at the outside lower corner of the overlapping block.

[Note]Note

You can also modify the shape of the crossfade curves. For information on setting curve shapes, refer to Specifying the Shape of the Curve Between Control Points.

To select a crossfade mode:

  1. Right-click the edge of a block and click a mode.

Related Topics

Was this page helpful?

Need Support?

Questions? Problems? Need more info? Contact us, and we can help!

Visit our Support page

Tell us about your project. We're here to help.

Register your project and we'll help you get started with no strings attached!

Get started with Wwise