Version
menu_open

Configuring Filter Behavior

The filter behavior is specified via the Project Settings.

[Caution]Caution

When changing the filter behavior, Wwise will:

  • Modify Work Units to adjust RTPC curves and State values for filter properties.

  • Save, close, then reload the Project.

The changes to the Work Units cannot be undone. Ensure that you have a saved copy of your project before changing the filter behavior, should you wish to revert later on.

To configure the filter behavior:

  1. Open the Project Settings dialog box by doing one of the following:

    • From the Project menu, select Project Settings.

    • Press Shift+K.

  2. Switch to the General tab.

  3. In the Filter Behavior group box, select the desired filter behavior:

    • Sum All Values (Default). Filter property values are summed.

    • Use Highest Value. Filter property values are maxed.

  4. Click OK to apply the settings.

Was this page helpful?

Need Support?

Questions? Problems? Need more info? Contact us, and we can help!

Visit our Support page

Tell us about your project. We're here to help.

Register your project and we'll help you get started with no strings attached!

Get started with Wwise