Specifying the Motion Signal's Cutoff Frequency

Wwise uses the low frequencies of an audio signal to generate the corresponding motion signal. To give you additional control and flexibility over which frequencies are kept and which ones are discarded, Wwise allows you to set the cut off frequency using the Motion Low Pass property.

info	Note
info	The Motion Low Pass property only determines which frequencies are extracted to generate the motion signal. It has no impact on the original sound.

To specify the motion signal's cut-off frequency:

Load an object into the Property Editor.
In the Audio to Motion Settings group box, modify the Motion Low Pass value to set the cutoff frequency that will be used to generate the motion signal.

Related Topics

Was this page helpful?

Need Support?

Questions? Problems? Need more info? Contact us, and we can help!

Visit our Support page

Tell us about your project. We're here to help.

Get started with Wwise

Wwise Help

Specifying the Motion Signal's Cutoff Frequency

Specifying the Motion Signal's Cutoff Frequency

Was this page helpful?

Need Support?

Tell us about your project. We're here to help.